Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| density | | ISO1183 | 1.45 g/cm³ |
| Shrinkage rate | | ISO294-4 | 0.83 % |
| Shrinkage rate | | ISO294-4 | 0.34 % |
| Water absorption rate | | ISO62 | 5.5 % |
| Water absorption rate | | ISO62 | 1.7 % |
| flammability | Test Condition | Test Method | Test Result |
|---|
| UL flame retardant rating | | IEC60695-11-10,-20 | HB |
| UL flame retardant rating | | IEC60695-11-10,-20 | HB |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| Tensile strain | Break | ISO527-2 | 3.0 % |
| Flexural modulus | | ISO178 | 10800 MPa |
| Bending stress | | ISO178 | 275 MPa |
| Tensile modulus | | ISO527-2 | 13000 MPa |
| Tensile stress | Break | ISO527-2 | 205 MPa |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Charpy Notched Impact Strength | | ISO179/1eA | 13 kJ/m² |
| Charpy Notched Impact Strength | | ISO179/1eA | 18 kJ/m² |
| Impact strength of simply supported beam without notch | | ISO179/1eU | 85 kJ/m² |
| Impact strength of simply supported beam without notch | | ISO179/1eU | 95 kJ/m² |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| Volume resistivity | | IEC60093 | 1E+14 ohms·cm |
| dielectric strength | | IEC60243-1 | 35 kV/mm |
| Surface Resistivity | | IEC60093 | -- ohms |
| Relative Permittivity | | IEC60250 | 3.50 |
| Relative Permittivity | | IEC60250 | 3.30 |
| Dissipation Factor | | IEC60250 | 5E-03 |
| Dissipation Factor | | IEC60250 | 0.015 |
| CTI | | IEC60112 | -- V |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| melting temperature | | ISO11357-3 | 220 °C |
| Linear thermal expansion coefficient | | ISO11359-2 | 2E-05 cm/cm/°C |
| Linear thermal expansion coefficient | | ISO11359-2 | 5E-05 cm/cm/°C |
| Heat Deflection Temperature | | ISO75-2/B | 220 °C |
| Heat Deflection Temperature | | ISO75-2/A | 200 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare