Technical Data Sheet
physical property | Test Condition | Test Method | Test Result |
---|
density | | ASTMD792 | 1.11 g/cm³ |
Melt volume flow rate | | ISO 1133 | 13.0 cm³/10min |
Melt volume flow rate | | ISO 1133 | 34.0 cm³/10min |
flammability | Test Condition | Test Method | Test Result |
---|
UL flame retardant rating | | UL 94 | V-0 |
Burning wire flammability index | | IEC 60695-2-12 | 960 °C |
Hot filament ignition temperature | | IEC 60695-2-13 | 725 °C |
Hot filament ignition temperature | | IEC 60695-2-13 | 725 °C |
Hot filament ignition temperature | | IEC 60695-2-13 | 725 °C |
UL flame retardant rating | | UL 94 | V-1 |
Mechanical properties | Test Condition | Test Method | Test Result |
---|
fracture | | ASTM D638 | 15 % |
fracture | | ISO 527-2/50 | 18 % |
yield | | ASTM D790 | 2100 MPa |
yield | | ASTM D638 | 43.0 MPa |
yield | | ISO 527-2/50 | 42.0 MPa |
fracture | | ASTM D638 | 43.0 MPa |
fracture | | ISO 527-2/50 | 42.0 MPa |
yield | | ASTM D638 | 1.0 % |
yield | | ISO 527-2/50 | 2.0 % |
Impact resistance | Test Condition | Test Method | Test Result |
---|
Charpy Notched Impact Strength | | ISO 179/1eA | 3.0 kJ/m² |
Charpy Notched Impact Strength | | ISO 179/1eA | 4.0 kJ/m² |
Electrical performance | Test Condition | Test Method | Test Result |
---|
Surface Resistivity | | ASTMD257 | 1E+16 ohms |
Volume resistivity | | ASTMD257 | 3E+16 ohms·cm |
Dissipation Factor | | ASTMD150 | 3.5E-03 |
Compared to the Leakage Tracking Index (CTI) | | UL 746 | PLC 2 |
Compared to the Leakage Tracking Index (CTI) | | IEC 60112 | PLC 2 |
Hot wire ignition (HWI) | | UL 746 | PLC 3 |
Thermal performance | Test Condition | Test Method | Test Result |
---|
RTI | | UL 746 | 65.0 °C |
Linear coefficient of thermal expansion | | ASTME831 | 9.4E-05 cm/cm/°C |
Linear coefficient of thermal expansion | | ASTME831 | 9.6E-05 cm/cm/°C |
RTI Elec | | UL 746 | 65.0 °C |
RTI Imp | | UL 746 | 65.0 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.