PBT/ASA LUMAX® EU5300
37
Compare
View PricesTechnical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|---|---|---|
| melt mass-flow rate | ASTM D1238 | 13 g/10 min | |
| Shrinkage rate - flow | ASTM D955 | 0.30 到 0.50 % | |
| Water absorption rate | ASTM D570 | 0.060 % |
| flammability | Test Condition | Test Method | Test Result |
|---|---|---|---|
| UL flame retardant rating | UL 94 | HB |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|---|---|---|
| tensile strength | ASTM D638 | 123 Mpa | |
| elongation | ASTM D638 | 2.0 % | |
| Flexural modulus | ASTM D790 | 8240 Mpa | |
| bending strength | ASTM D790 | 177 Mpa |
| injection | Test Condition | Test Method | Test Result |
|---|---|---|---|
| drying temperature | 120 °C | ||
| drying time | 4.0 到 6.0 hr | ||
| Suggested maximum moisture content | 0.020 % | ||
| Temperature at the rear of the barrel | 240 到 260 °C | ||
| Temperature in the middle of the barrel | 240 到 260 °C | ||
| Temperature at the front of the material cylinder | 245 到 265 °C | ||
| Spray nozzle temperature | 245 到 265 °C | ||
| Processing (melt) temperature | 240 到 260 °C | ||
| Temperature | 40 到 80 °C |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|---|---|---|
| Thermal deformation temperature under load | ASTM D648 | 195 °C | |
| ASTM D3418 | 223 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
You May Like
Contact Us
Get App
Top