Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| Shrinkage rate | | ASTM D995 | 0.15 % |
| Shrinkage rate | | ASTM D995 | 0.30 % |
| Shrinkage rate | | | 1.80-1.95 g/cm³ |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| bending strength | | ASTM D790 | 124 MPa |
| Flexural modulus | | ASTM D790 | 11700 MPa |
| Impact strength of cantilever beam gap | | ASTM D256 | 530 J/m |
| Suspended wall beam without notch impact strength | | ASTM D4812 | 690 J/m |
| Suspended wall beam without notch impact strength | | | 0.3 |
| Suspended wall beam without notch impact strength | | | 5200 MPa |
| tensile strength | | ASTM D638 | 33 MPa |
| Tensile modulus | | ASTM D638 | 13400 MPa |
| Other performance | Test Condition | Test Method | Test Result |
|---|
| Clamping pressure | | | 3.45-6.89 MPa |
| Flame retardant performance | Test Condition | Test Method | Test Result |
|---|
| UL flame retardant rating | | UL -94 | 5VB 2.60mm |
| UL flame retardant rating | | UL -94 | V-0 1.60mm |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| dielectric strength | | ASTM D149 | 15 KV/mm |
| Dissipation Factor | | ASTM D495 | 210 sec |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| Heat distortion temperature | | ASTM D648 | >=200 °C |
| Linear coefficient of thermal expansion | | ASTM D696 | 3.5E-05 cm/cm／°C |
| Linear coefficient of thermal expansion | | ASTM D696 | 2.5E-05 cm/cm／°C |
| Linear coefficient of thermal expansion | | JISR2618 | 0.3 W/m/K |
| Linear coefficient of thermal expansion | | | 150 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare