Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| density | | ISO 1183 | 1.48 g/cm³ |
| melt mass-flow rate | | ISO 1133 | 6.0 g/10min |
| Water absorption rate | | IEC 60811-1-3 | 0.500 mg/cm² |
| Mooney viscosity | | ASTM D792 | 39 MU |
| pH value | | | 5.9 |
| hardness | Test Condition | Test Method | Test Result |
|---|
| Shore hardness | | ISO 868 | 52 |
| flammability | Test Condition | Test Method | Test Result |
|---|
| Limiting Oxygen Index | | ISO 4589-2 | 36 % |
| HalogenContent | | IEC 754-1 | <5 mg/g |
| toxicity | | EN50305 | 2.30 |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| Tensile strain | | IEC 60811-1-1 | -17 % |
| Tensile strain | Break | IEC 60811-1-1 | 180 % |
| Tensile strain | | IEC 60811-1-1 | 160 % |
| Tensile strain | | IEC 60811-1-1 | -6.0 % |
| tensile strength | | IEC 60811-1-1 | 11.0 MPa |
| tensile strength | | IEC 60811-1-1 | 10.7 MPa |
| aging | Test Condition | Test Method | Test Result |
|---|
| Change rate of tensile strength in air | | BS6724 | 94 % |
| Elongation retention rate | | BS6724 | 97 % |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| Surface Resistivity | | IEC 60093 | 3.7E+14 ohms |
| Surface Resistivity | | IEC 60093 | 4.8E+14 ohms |
| Volume resistivity | | IEC 60093 | 3.6E+14 ohms·cm |
| dielectric constant | | IEC 60250 | 3.70 |
| dielectric constant | | IEC 60250 | 6.10 |
| Dissipation Factor | | IEC 60250 | 0.026 |
| Dissipation Factor | | IEC 60250 | 0.13 |
| Dissipation Factor | | IEC 60250 | 2.80 µS/cm |
| Volume resistivity | | IEC 60093 | 1.1E+15 ohms·cm |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| ColdElongation | | IEC 60811-1-4 | 140 % |
| Hot pressing test | | IEC 60811-3-1 | 5.0 % |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare