Technical Data Sheet
physical property | Test Condition | Test Method | Test Result |
---|
density | | g/cm³ | 1.15 -- |
Water absorption rate | | % | 6.6 -- |
Water absorption rate | | % | 2.4 -- |
Water absorption rate | | mg | 50.0 -- |
Water absorption rate | | mg | 94.0 -- |
hardness | Test Condition | Test Method | Test Result |
---|
Rockwell hardness | | | 85 -- |
Shore hardness | | | 80 -- |
ball-indentation hardness | | MPa | 160 -- |
flammability | Test Condition | Test Method | Test Result |
---|
UL flame retardant rating | | | HB -- |
UL flame retardant rating | | | HB -- |
Limiting Oxygen Index | | % | 25 -- |
Mechanical properties | Test Condition | Test Method | Test Result |
---|
Tensile creep modulus | | MPa | 21.0 10.0 |
compression stress | | MPa | 85.0 -- |
compression stress | | MPa | 48.0 -- |
compression stress | | MPa | 25.0 -- |
Tensile strain | | % | 15 >50 |
Tensile modulus | | MPa | 3200 1500 |
tensile strength | | MPa | 80.0 50.0 |
Impact resistance | Test Condition | Test Method | Test Result |
---|
Charpy Notched Impact Strength | | kJ/m² | 3.5 -- |
Impact strength of simply supported beam without notch | | | 无断裂 -- |
Impact strength of cantilever beam gap | | kJ/m² | 3.5 6.0 |
Electrical performance | Test Condition | Test Method | Test Result |
---|
Surface Resistivity | | ohms | >1.0E+13 >1.0E+12 |
Volume resistivity | | ohms·cm | >1.0E+14 >1.0E+12 |
dielectric strength | | kV/mm | 25 17 |
relative permittivity | | | 3.60 6.60 |
relative permittivity | | | 3.20 3.70 |
Dissipation Factor | | | 0.012 0.14 |
Dissipation Factor | | | 0.016 0.050 |
Compared to the Leakage Tracking Index (CTI) | | V | PLC 0 |
Thermal performance | Test Condition | Test Method | Test Result |
---|
Heat distortion temperature | | °C | 80.0 -- |
melting temperature | | °C | 220 -- |
maximum service temperature | | °C | 120 -- |
maximum service temperature | | °C | 170 -- |
Linear coefficient of thermal expansion | | cm/cm/°C | 8E-05 -- |
Linear coefficient of thermal expansion | | cm/cm/°C | 9E-05 -- |
thermal conductivity | | W/m/K | 0.29 -- |
Minimum operating temperature | | °C | -40 -- |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.