PUR，Unspecified

PUR，Unspecified EN-2552 ELANTAS PDG Inc.

Compare

Technical Data Sheet

Cured Properties	Test Condition	Test Method	Test Result
Shrinkage rate			0.75 %

flammability	Test Condition	Test Method	Test Result
UL flame retardant rating	6.4mm	UL 94	V-0

elastomer	Test Condition	Test Method	Test Result
tear strength			27.0 kN/m

mechanical properties	Test Condition	Test Method	Test Result
tensile strength			7.07 MPa
elongation	Break		39 %

thermosetting	Test Condition	Test Method	Test Result
Thermosetting components	Resin		按重量计算的混合比:17
Thermosetting components	Thermosetting components	按重量计算的混合比		100
Thermosetting mixed viscosity	25°C3		300 cP
	Thermosetting mixed viscosity	25°C5		8500 cP
		Thermosetting mixed viscosity	25°C4		4500 cP
		Thermosetting mixed viscosity	Thermosetting mixed viscosity	GelTime-100gmmass(25°C)		12.0to15.0 min

thermal performance	Test Condition	Test Method	Test Result
Linear coefficient of thermal expansion	MD		1.2E-04 cm/cm/°C
thermal conductivity			0.65 W/m/K

Physical properties	Test Condition	Test Method	Test Result
Water absorption rate	7dayimmersion:25°C		0.15 %
density	--3		1.24 g/cm³
	density	--4		1.46 g/cm³
	density	density	--5		1.48 g/cm³
Water absorption rate	24hourimmersion:25°C		0.060 %

Electrical performance	Test Condition	Test Method	Test Result
Dielectric constant	25°C,1kHz		3.99
Dissipation factor	25°C,100Hz		0.18
	Dissipation factor	25°C,1kHz		0.053
		Dissipation factor	耐电弧性		>120 sec
		Dissipation factor	Dissipation factor	InsulationResistance(25°C)		8.6E+12 ohms
Surface resistivity			2.8E+17 ohms
Volume resistivity	25°C		6.8E+13 ohms·cm
Dielectric strength			23 kV/mm

hardness	Test Condition	Test Method	Test Result
Shore hardness	ShoreD		90

Supplementary Information	Test Condition	Test Method	Test Result
Curing Procedure	25°C		7.0 day
	Curing Procedure	80°C		0.7 day
	Curing Procedure	Curing Procedure	LapShear-AdhesiontoAluminum		2.07 MPa

IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.

Get App

Top