PC/CF CF15
35
Compare
View PricesTechnical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|---|---|---|
| Shrinkage rate - flow | ASTM D955 | 0.15 % | |
| Water absorption rate | ASTM D570 | 0.15 % |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|---|---|---|
| Tensile modulus | ASTM D638 | 9720 Mpa | |
| tensile strength | ASTM D638 | 121 Mpa | |
| elongation | ASTM D638 | 2.0 % | |
| Flexural modulus | ASTM D790 | 11000 Mpa | |
| bending strength | ASTM D790 | 172 Mpa |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|---|---|---|
| Surface Resistivity | ASTM D257 | 1.0E+2 到 5.5E+5 ohms | |
| Volume resistivity | ASTM D257 | 1.0E+2 到 1.0E+5 ohms·cm |
| injection | Test Condition | Test Method | Test Result |
|---|---|---|---|
| drying temperature | 121 °C | ||
| drying time | 2.0 到 4.0 hr | ||
| Suggested maximum moisture content | 0.10 % | ||
| Temperature at the rear of the barrel | 302 到 316 °C | ||
| Temperature in the middle of the barrel | 316 到 332 °C | ||
| Temperature at the front of the material cylinder | 310 到 327 °C | ||
| Spray nozzle temperature | 310 到 327 °C | ||
| Processing (melt) temperature | 304 到 327 °C | ||
| Temperature | 71 到 88 °C | ||
| injection speed | 中等 | ||
| Back pressure | 0.00 到 0.689 Mpa |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|---|---|---|
| Thermal deformation temperature under load | ASTM D648 | 146 °C | |
| ASTM D648 | 142 °C | ||
| ASTM D696 | 3.2E-5 cm/cm/°C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
You May Like
Contact Us
Get App
Top