thermal performance	Test Condition	Test Method	Test Result
Heat Deflection Temperature	1.8 MPa, 未退火, 3.20 mm	ASTM D648	114 °C
Linear coefficient of thermal expansion	流动 : -40 到 40°C		0.000062 cm/cm/°C
Linear coefficient of thermal expansion	Linear coefficient of thermal expansion	垂直 : -40 到 40°C		0.000067 cm/cm/°C
RTI Elec		UL 746B	80 °C
RTI Imp		UL 746B	80 °C
RTI		UL 746B	80 °C

flammability	Test Condition	Test Method	Test Result
UL flame retardant rating	0.60mm	UL 94	V-0

Physical properties	Test Condition	Test Method	Test Result
melt mass-flow rate	300°C/1.2 kg	ASTM D1238	12 g/10 min
shrinkage rate	流动 : 24小时		0.5 %
shrinkage rate	shrinkage rate	横向流动 : 24小时		0.5 %
water absorption rate	24 hr, 23°C, 50% RH	ASTM D570	0.01 %

Electrical performance	Test Condition	Test Method	Test Result
relative permittivity	1.00 GHz	IEC 60250	2.92
Dissipation Factor	1.00 GHz	IEC 60250	0.007

injection	Test Condition	Test Method	Test Result
drying temperature			100 to 110 °C
drying time			3.0 to 4.0 hr
Suggested maximum moisture content			0.02 %
Suggested injection volume			30 to 80 %
Hopper temperature			60 to 80 °C
Temperature at the rear of the barrel			250 to 290 °C
Temperature in the middle of the barrel			255 to 295 °C
Temperature at the front of the material cylinder			260 to 300 °C
Spray nozzle temperature			275 to 300 °C
Processing (melt) temperature			275 to 300 °C
mold temperature			60 to 90 °C
Back pressure			0.300 to 0.700 Mpa
screw speed			40 to 70 rpm
Exhaust hole depth			0.038 to 0.076 mm

mechanical properties	Test Condition	Test Method	Test Result
tensile modulus		ASTM D638	2600 Mpa
tensile strength	屈服		58 Mpa
tensile strength	tensile strength	断裂		52 Mpa
elongation	屈服		5.4 %
elongation	elongation	断裂		70 %
flexural modulus	50.0 mm 跨距	ASTM D790	2400 Mpa
bending strength	屈服, 50.0 mm 跨距		90 Mpa
bending strength	bending strength	断裂, 50.0 mm 跨距		89 Mpa

impact performance	Test Condition	Test Method	Test Result
Impact strength of cantilever beam gap	23°C	ASTM D4812	2100 J/m

IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.

Get App

Top