Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| density | | ASTMD792 | 1.28 g/cm³ |
| melt mass-flow rate | | ASTMD1238 | 16 g/10min |
| Shrinkage rate | | ASTMD955 | 0.014到0.018 % |
| Water absorption rate | | ASTMD570 | 0.30 % |
| hardness | Test Condition | Test Method | Test Result |
|---|
| | ASTMD2240 | 74 |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| elongation | | ASTMD638 | 350 % |
| Flexural modulus | | ASTMD790 | 1080 MPa |
| tensile strength | | ASTMD638 | 34.3 MPa |
| tensile strength | | ASTMD638 | 49.0 MPa |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Impact strength of cantilever beam gap | | ASTMD256 | 29 J/m |
| Impact strength of cantilever beam gap | | ASTMD256 | 39 J/m |
| elastomer | Test Condition | Test Method | Test Result |
|---|
| tear strength | | ASTMD624 | 167 kN/m |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| Volume resistivity | | ASTMD257 | >1.0E+13 ohms·cm |
| dielectric strength | | ASTMD149 | 26 kV/mm |
| CTI | | IEC60112 | 600 V |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| Heat distortion temperature | | ASTMD648 | 145 °C |
| | ASTMD3418 | 220 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare