Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| Shrinkage rate | | ASTM D955 | 0.60 - 0.80 % |
| water content | | | < 0.020 % |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| Tensile modulus | | ASTM D638 | 2140 Mpa |
| tensile strength | | ASTM D638 | 58.6 Mpa |
| elongation | | ASTM D638 | 8.0 % |
| Flexural modulus | | ASTM D790 | 2280 Mpa |
| bending strength | | ASTM D790 | 82.0 Mpa |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Suspended wall beam without notch impact strength | | ASTM D4812 | 无断裂 |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| Surface Resistivity | | ESD STM11.11 | 1.0E+5 - 1.0E+9 ohms |
| Surface Resistivity | | ASTM D257 | 1.0E+6 - 1.0E+10 ohms |
| Volume resistivity | | ASTM D257 | 1.0E+2 - 1.0E+5 ohms·cm |
| static decay | | FTMS 101C 4046.1 | < 2.0 sec |
| injection | Test Condition | Test Method | Test Result |
|---|
| drying temperature | | | 79 °C |
| drying time | | | 4.0 hr |
| Dew point temperature | | | -40 °C |
| Processing (melt) temperature | | | 232 to 282 °C |
| Temperature | | | 49 to 93 °C |
| Injection Pressure | | | 68.9 to 103 Mpa |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| Heat distortion temperature | | ASTM D648 | 64.4 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare
View Prices