PC GN2101FC LG YX NINGBO

Form：Granules | Grade：Injection grade

Properties:

heat-resistingenhanceFlame retardantHalogen-free

Typical Applications:

Fiber gradeElectrical fieldElectronic field

Supplier(0)

Product Description

Certificates(0)

Datasheet

Product Description

Typical Applications:	Fiber grade \| Electrical field \| Electronic field
Properties:	heat-resisting \| enhance \| Flame retardant \| Halogen-free

Certificates

No Data...

Technical Data Sheet

impact performance	Test Condition	Test Method	Test Result	Test Unit
Impact strength of cantilever beam gap	23°C, 3.20 mm, Injection	ASTM D256	78	J/m
flammability	Test Condition	Test Method	Test Result	Test Unit
UL flame retardant rating	3.0 mm	UL 94	V-0
UL flame retardant rating	UL flame retardant rating	1.5 mm	UL 94	V-0
mechanical properties	Test Condition	Test Method	Test Result	Test Unit
bending strength	23°C, 3.20 mm, Injection	ASTM D790	137	Mpa
Bending modulus	23°C, 3.20 mm, Injection	ASTM D790	3920	Mpa
tensile strength	Yield, 23°C, 3.20 mm, Injection	ASTM D638	83.4	Mpa
injection	Test Condition	Test Method	Test Result	Test Unit
Screw speed			40 to 70	rpm
Back pressure			0.981 to 3.92	Mpa
Mold temperature			90 to 120	°C
Processing (melt) temperature			300 to 340	°C
Spray nozzle temperature			290 to 330	°C
Suggested maximum moisture content			0.020	%
drying time			3.0 to 5.0	hr
drying temperature			100 to 200	°C
Temperature at the front of the material cylinder			290 to 330	°C
Temperature in the middle of the barrel			280 to 310	°C
Temperature at the rear of the barrel			270 to 300	°C
thermal performance	Test Condition	Test Method	Test Result	Test Unit
RTI		UL 746	105	°C
RTI Imp		UL 746	90.0	°C
RTI Elec		UL 746	120	°C
Hot deformation temperature	1.8 MPa, Unannealed, 6.40 mm, Injection	ASTM D648	138	°C
Physical properties	Test Condition	Test Method	Test Result	Test Unit
Shrinkage rate	23°C, 3.20 mm, Injection，Flow	ASTM D955	0.20 - 0.40	%
melt mass-flow rate	300°C/1.2 kg	ASTM D1238	18	g/10 min
density		ASTM D792	1.25	g/cm³
hardness	Test Condition	Test Method	Test Result	Test Unit
Rockwell hardness	R-Scale, 23°C, Injection	ASTM D785	124

IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.

Get App

Top