
Product Description
Certificates(0)
Datasheet
Product Description
Certificates
No Data...
Technical Data Sheet
| flammability | Test Condition | Test Method | Test Result | Test Unit |
|---|---|---|---|---|
| UL flame retardant rating | 1.2 mm | UL 94 | V-1 | |
| 1.5 mm | UL 94 | V-0 | ||
| mechanical properties | Test Condition | Test Method | Test Result | Test Unit |
| tensile strength | ISO 527-2 | 130 | Mpa | |
| Bending modulus | ISO 178 | 11000 | Mpa | |
| bending strength | ISO 178 | 205 | Mpa | |
| injection | Test Condition | Test Method | Test Result | Test Unit |
| drying temperature | 80 to 120 | °C | ||
| drying time | 3.0 to 5.0 | hr | ||
| Temperature at the rear of the barrel | 190 to 230 | °C | ||
| Temperature in the middle of the barrel | 220 to 240 | °C | ||
| Temperature at the front of the material cylinder | 240 to 250 | °C | ||
| Spray nozzle temperature | 230 to 250 | °C | ||
| Mold temperature | 60 to 80 | °C | ||
| Back pressure | 5.00 to 20.0 | Mpa | ||
| Screw speed | 50 to 90 | rpm | ||
| thermal performance | Test Condition | Test Method | Test Result | Test Unit |
| Hot deformation temperature | 1.8 MPa, Unannealed | ISO 75-2/A | 155 | °C |
| Physical properties | Test Condition | Test Method | Test Result | Test Unit |
| Shrinkage rate | Flow | ASTM D955 | 0.20 - 0.40 | % |
| Electrical performance | Test Condition | Test Method | Test Result | Test Unit |
| Surface resistivity | Internal Method | 4.0E+2 | ohms | |
| Volume resistivity | Internal Method | 1.0E+2 | ohms·cm |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.