Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| Melt volume flow rate | | ISO1133 | 3.00 cm3/10min |
| Shrinkage rate | | ISO294-4 | 0.20到0.40 % |
| Ash Content | | | 16 % |
| hardness | Test Condition | Test Method | Test Result |
|---|
| | ISO2039-1 | 135 Mpa |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| Tensile strain | | ISO527-2 | 2.0 % |
| Flexural modulus | | ISO178 | 5400 Mpa |
| Bending stress | | ISO178 | 101 Mpa |
| Tensile modulus | | ISO527-2 | 5500 Mpa |
| Tensile stress | | ISO527-2 | 74.0 Mpa |
| Tensile stress | | ISO527-2 | 74.0 Mpa |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Impact strength of simply supported beam without notch | | ISO179 | 20 kJ/m² |
| Impact strength of simply supported beam without notch | | ISO179 | 18 kJ/m² |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| Surface Resistivity | | IEC60093 | 1E+14 ohms |
| Volume resistivity | | IEC60093 | >1.0E+15 ohms·cm |
| dielectric strength | | IEC60243-1 | 32 KV/mm |
| | IEC60250 | 2.90 |
| | IEC60250 | 3.10 |
| Dissipation Factor | | IEC60250 | 5E-03 |
| Dissipation Factor | | IEC60250 | 6E-03 |
| CTI | | IEC60112 | 575 V |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| Hot deformation temperature 3 | | ISO75-2/B | 106 °C |
| Hot deformation temperature 3 | | ISO75-2/A | 102 °C |
| vicat | | ISO306/B50 | 105 °C |
| | ISO11359-1 | 4E-05 cm/cm/°C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare
View Prices