TPE 2180
0
- Properties:Injection molding reference process: temperature at the rear of the barrel140-160 ℃holding pressure30-120MPatemperature at the middle of the barrel150-170 ℃mold temperature20-50 ℃temperature at the front of the barrel160-180 ℃holding time15-75S nozzle temperature170-190 ℃screw speed20-100rmininjection pressure40-150MPainjection speed?
CompareTechnical Data Sheet
| Basic performance | Test Condition | Test Method | Test Result |
|---|---|---|---|
| relative density | 1.25 g/cm |
| Other performance | Test Condition | Test Method | Test Result |
|---|---|---|---|
| Tensile strength retention rate | 108 % | ||
| Constant tensile strength retention rate | 127 % | ||
| Retention rate of elongation at break | 87 % | ||
| Volume change of fuel B | -7 % | ||
| permanent set | 45 % |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|---|---|---|
| tensile strength | 13.5 MPa | ||
| tear strength | 52.0 kN/m | ||
| Shore hardness | 80 A | ||
| Elongation | 380 % | ||
| stretching strength | 6.0 MPa |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Contact Us
Get App
Top