
PA66 27GF-03 HENAN SHENMA NYLON
115
Form:Granules | Grade:Flame retardant enhanced grade
Properties:
Flame retardantGlass fiber reinforcedHigh temperature resistan
Typical Applications:
Automotive External PartsElectrical applications
Product Description
Certificates(0)
Datasheet
Product Description
| Typical Applications: | Automotive External Parts | Electrical applications |
| Properties: | Flame retardant | Glass fiber reinforced | High temperature resistan |
Certificates
No Data...
Technical Data Sheet
| Other performance | Test Condition | Test Method | Test Result | Test Unit |
|---|---|---|---|---|
| Water absorption rate | 23℃Saturation | ISO 62 | -- | % |
| density | ISO 1183 | -- | g/cm³ | |
| Shrinkage rate | 垂直,- | - | -- | % |
| 平行,- | - | -- | % | |
| mechanical properties | Test Condition | Test Method | Test Result | Test Unit |
| Charpy Notched Impact Strength | Dry | ISO 179 | 16.9 | kJ/m² |
| Impact strength of simply supported beam without notch | Dry | ISO 179 | 69.1 | kJ/m² |
| Bending modulus | Dry | ISO 178 | 6.5 | GPa |
| Elongation at Break | Dry | ISO 527 | 5.0 | % |
| tensile strength | Dry | ISO 527 | 124.6 | Mpa |
| bending strength | Dry | ISO 178 | 189.8 | Mpa |
| Impact strength of cantilever beam gap | Dry | ISO 180 | -- | kJ/m² |
| Tensile modulus | Dry | ISO 527 | -- | GPa |
| thermal performance | Test Condition | Test Method | Test Result | Test Unit |
| Hot deformation temperature | 1.80MPa | ISO 75 | -- | °C |
| Linear coefficient of thermal expansion | ISO 11359 | -- | 10-5k | |
| melt mass-flow rate | Dry | ISO 1133 | -- | g/10min |
| Melting temperature | Dry | ISO 3146 | -- | °C |
| Electrical performance | Test Condition | Test Method | Test Result | Test Unit |
| Dielectric strength | Dry | IEC 243 | -- | KV/mm |
| Volume resistivity | Dry/湿态 | IEC 93 | -- | Ω.cm |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.