
PBT 5710G30-S2-BK MITSUBISHI ENGINEERING JAPAN
104
Form:Granules | Grade:Enhanced level
Properties:
Glass fiber reinforcedFlame retardantFiller: Glass fiber reinf30%Filler by weight
Typical Applications:
Vehicle electronicsFitness equipmentBottle cap
Product Description
Certificates(0)
Datasheet
Product Description
| Typical Applications: | Vehicle electronics | Fitness equipment | Bottle cap |
| Properties: | Glass fiber reinforced | Flame retardant | Filler: Glass fiber reinf | 30% | Filler by weight |
Certificates
No Data...
Technical Data Sheet
| impact performance | Test Condition | Test Method | Test Result | Test Unit |
|---|---|---|---|---|
| Impact strength of simply supported beam without notch | 23°C | ISO 179 | 52 | kJ/m² |
| mechanical properties | Test Condition | Test Method | Test Result | Test Unit |
| bending strength | ISO 178 | 190 | Mpa | |
| Tensile strain | Break | ISO 527-2 | 2.0 | % |
| tensile strength | Break | ISO 527-2 | 130 | Mpa |
| Tensile modulus | ISO 527-2 | 10500 | Mpa | |
| Bending modulus | ISO 178 | 9000 | Mpa | |
| thermal performance | Test Condition | Test Method | Test Result | Test Unit |
| Linear coefficient of thermal expansion | TD:50to120°C | ISO 11359-2 | 1.2E-04 | cm/cm/°C |
| TD:-30to120°C | ISO 11359-2 | 1E-04 | cm/cm/°C | |
| TD:-30to50°C | ISO 11359-2 | 7E-05 | cm/cm/°C | |
| MD:50to120°C | ISO 11359-2 | 1E-05 | cm/cm/°C | |
| MD:-30to120°C | ISO 11359-2 | 1E-05 | cm/cm/°C | |
| MD:-30to50°C | ISO 11359-2 | 1E-05 | cm/cm/°C | |
| Melting temperature | ISO 11357-3 | 224 | °C | |
| Hot deformation temperature | 1.8MPa,Unannealed | ISO 75-2/A | 194 | °C |
| 0.45MPa,Unannealed | ISO 75-2/B | 220 | °C | |
| Physical properties | Test Condition | Test Method | Test Result | Test Unit |
| Shrinkage rate | 吸水率(Saturation,23°C) | 0.070 | % | |
| MD:2.00mm | 0.40 | % | ||
| TD:2.00mm | 0.80 | % | ||
| Electrical performance | Test Condition | Test Method | Test Result | Test Unit |
| Dissipation factor | 1MHz | IEC 60250 | 0.020 | |
| Relative permittivity | 1MHz | IEC 60250 | 3.40 | |
| Dielectric strength | 2.00mm | IEC 60243-1 | 24 | KV/mm |
| 1.00mm | IEC 60243-1 | 28 | KV/mm | |
| Volume resistivity | IEC 60093 | 9E+16 | ohms·cm | |
| Surface resistivity | IEC 60093 | 5E+15 | ohms |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.