Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| density | | ISO 1183 | 1.77 g/cm³ |
| Shrinkage rate | | 内部方法 | 0.10-0.30 % |
| Water absorption rate | | ISO 62 | 0.13 % |
| Water absorption - Ejil, 65% RH | | 内部方法 | 1.3 % |
| flammability | Test Condition | Test Method | Test Result |
|---|
| Hot filament ignition temperature | | IEC 60695-2-13 | 825 °C |
| Limiting Oxygen Index | | ISO 4589-2 | 25 % |
| UL flame retardant rating | | UL 94 | HB |
| Burning wire flammability index | | IEC 60695-2-12 | 775 °C |
| Burning wire flammability index | | IEC 60695-2-12 | 775 °C |
| Burning wire flammability index | | IEC 60695-2-12 | 960 °C |
| Hot filament ignition temperature | | IEC 60695-2-13 | 800 °C |
| Hot filament ignition temperature | | IEC 60695-2-13 | 800 °C |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| Tensile modulus | | ISO 527-2 | 24000 Mpa |
| tensile strength | | ISO 527-2 | 280 Mpa |
| Tensile strain | | ISO 527-2 | 1.8 % |
| Flexural modulus | | ISO 178 | 23500 Mpa |
| bending strength | | ISO 178 | 400 Mpa |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Impact strength of cantilever beam gap | | ASTM D256 | 120 J/m |
| Impact strength of cantilever beam gap | | ASTM D256 | 900 J/m |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| Volume resistivity | | IEC 60093 | 1E+13 ohms·cm |
| dielectric strength | | IEC 60243-1 | 24 KV/mm |
| dielectric constant | | IEC 60250 | 4.50 |
| Dissipation Factor | | IEC 60250 | 9E-03 |
| Compared to the Leakage Tracking Index (CTI) | | IEC 60112 | V |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| Heat distortion temperature | | ISO 75-2/A | 230 °C |
| Linear coefficient of thermal expansion | | ISO 11359-2 | 1.4E-05 cm/cm/°C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare
View Prices