Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| density | | ASTM D792 | 1.16 g/cm³ |
| | ASTM D1238 | 8.0 g/10 min |
| flammability | Test Condition | Test Method | Test Result |
|---|
| UL flame retardant rating | | UL 94 | V-0 |
| squeeze out | Test Condition | Test Method | Test Result |
|---|
| die temperature | | | 190 到 220 °C |
| drying temperature | | | 70.0 °C |
| drying time | | | 1.0 到 2.0 hr |
| Material cylinder | | | 160 到 200 °C |
| Material cylinder | | | 180 到 220 °C |
| Material cylinder | | | 200 到 240 °C |
| Material cylinder | | | 200 到 240 °C |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| tensile strength | | ASTM D638 | 28.4 MPa |
| elongation | Break | ASTM D638 | 45 % |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Impact strength of cantilever beam gap | | ASTM D256 | 98 J/m |
| injection | Test Condition | Test Method | Test Result |
|---|
| Temperature in the middle of the barrel | | | 190 到 220 °C |
| drying temperature | | | 70.0 °C |
| drying time | | | 1.0 到 2.0 hr |
| Temperature at the rear of the barrel | | | 180 到 210 °C |
| Spray nozzle temperature | | | 200 到 230 °C |
| Temperature | | | 40.0 到 60.0 °C |
| Temperature at the front of the material cylinder | | | 210 到 240 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare