
PC 940A-116 SABIC INNOVATIVE US
269
Form:Granules | Grade:Injection grade
Properties:
Medium viscosity
Product Description
Certificates(1)
Datasheet
Product Description
| Properties: | Medium viscosity |
Certificates

Technical Data Sheet
| Basic Performance | Test Condition | Test Method | Test Result | Test Unit |
|---|---|---|---|---|
| Water absorption rate | --- | ASTM D-570 | 0.15 | % |
| melt mass-flow rate | --- | ASTM D-1238 | 7 | g/10min |
| mechanical properties | Test Condition | Test Method | Test Result | Test Unit |
| Bending modulus | --- | ASTM D-790 | 3250 | Mpa |
| tensile strength | Yield点,--- | ASTM D-638 | 62 | Mpa |
| Impact strength of cantilever beam gap | 23℃ | ASTM D-256 | 640 | J/m |
| tensile strength | Break点,--- | ASTM D-638 | 56 | Mpa |
| Elongation at Break | --- | ASTM D-638 | 90 | % |
| Rockwell hardness | --- | ASTM D-785 | 118 | --- |
| bending strength | --- | ASTM D-790 | 91 | Mpa |
| thermal performance | Test Condition | Test Method | Test Result | Test Unit |
| Hot deformation temperature | 0.45MPa | ASTM D-648 | 137 | °C |
| Physical properties | Test Condition | Test Method | Test Result | Test Unit |
| Shrinkage rate | 3.2mm | ASTM D-955 | 5-7 | 10 |
| UL flame retardant rating | --- | UL 94 | 3.0 | mm |
| density | --- | ASTM D-792 | 1.21 | --- |
| UL flame retardant rating | --- | UL 94 | 1.6 | mm |
| --- | UL 94 | V-2 | --- | |
| --- | UL 94 | V-0 | --- | |
| Electrical performance | Test Condition | Test Method | Test Result | Test Unit |
| Dielectric constant | 60Hz | ASTM D-150 | 3.01 | --- |
| Volume resistivity | --- | ASTM D-257 | 1.0×10 | Ω.cm |
| Dielectric constant | 1MHz | ASTM D-150 | 2.96 | --- |
| Dissipation factor | 1MHz | ASTM D-150 | 0.01 | --- |
| 60Hz | ASTM D-150 | 0.0009 | --- |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.