
PPS HONES® PPS HS-B7-N Guangdong Shunde Hones Polymer Material Co., Ltd.
Product Description
Certificates(0)
Datasheet
Product Description
Certificates
No Data...
Technical Data Sheet
| Filling analysis | Test Condition | Test Method | Test Result | Test Unit |
|---|---|---|---|---|
| MeltViscosity | 310°C | ISO 11443 | 280 | Pa·s |
| flammability | Test Condition | Test Method | Test Result | Test Unit |
| UL flame retardant rating | UL 94 | V-0 | ||
| mechanical properties | Test Condition | Test Method | Test Result | Test Unit |
| bending strength | Internal Method | 175 | MPa | |
| elongation | Break | Internal Method | 1.0 | % |
| tensile strength | Internal Method | 90.0 | MPa | |
| Bending modulus | Internal Method | 7200 | MPa | |
| thermal performance | Test Condition | Test Method | Test Result | Test Unit |
| Linear coefficient of thermal expansion | TD | ISO 11359-2 | 3E-05 | cm/cm/°C |
| MD | ISO 11359-2 | 1E-05 | cm/cm/°C | |
| Hot deformation temperature | 1.8MPa,Unannealed | Internal Method | 275 | °C |
| Physical properties | Test Condition | Test Method | Test Result | Test Unit |
| Water absorption rate | 23°C,24hr | ISO 62 | 0.010 | % |
| Shrinkage rate | TD:2.00mm | Internal Method | 0.30 | % |
| MD:2.00mm | Internal Method | 0.15 | % | |
| density | Internal Method | 2.05 | g/cm³ | |
| Electrical performance | Test Condition | Test Method | Test Result | Test Unit |
| Dielectric strength | 3.00mm | IEC 60243-1 | 19 | kV/mm |
| Volume resistivity | IEC 60093 | 2E+16 | ohms·cm | |
| Surface resistivity | IEC 60093 | 2E+16 | ohms | |
| Compared to the anti leakage trace index | IEC 60112 | PLC 3 | ||
| Dissipation factor | 1MHz | IEC 60250 | 5E-03 | |
| 1kHz | IEC 60250 | 0.013 | ||
| Dielectric constant | 1MHz | IEC 60250 | 5.40 | |
| 1kHz | IEC 60250 | 5.40 |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.