Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| density | | ISO1183 | 1.02 g/cm³ |
| Melt volume flow rate | | ISO1133 | 14.0 cm3/10min |
| Shrinkage rate | | ISO294-4 | 0.40到0.70 % |
| Water absorption rate | | ISO62 | 1.0 % |
| Water absorption rate | | ISO62 | 0.21 % |
| hardness | Test Condition | Test Method | Test Result |
|---|
| Rockwell hardness | | ISO2039-2 | 101 |
| | ISO2039-1 | 80.0 Mpa |
| flammability | Test Condition | Test Method | Test Result |
|---|
| UL flame retardant rating | | UL94 | HB |
| UL flame retardant rating | | UL94 | HB |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| Bending stress | | ISO178 | 58.0 Mpa |
| Tensile modulus | | ISO527-2 | 1900 Mpa |
| Tensile stress | | ISO527-2 | 40.0 Mpa |
| Tensile strain | | ISO527-2 | 2.7 % |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Charpy Notched Impact Strength | | ISO179 | 11 kJ/m² |
| Charpy Notched Impact Strength | | ISO179 | 30 kJ/m² |
| Impact strength of simply supported beam without notch | | ISO179 | 160 kJ/m² |
| Impact strength of simply supported beam without notch | | ISO179 | 无断裂 |
| Impact strength of cantilever beam gap | | ASTMD256 | 35.0 kJ/m² |
| Impact strength of cantilever beam gap | | ISO180/A | 11 kJ/m² |
| Impact strength of cantilever beam gap | | ISO180/A | 31 kJ/m² |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| CTI | | IEC60112 | 600 V |
| Volume resistivity | | IEC60093 | 1E+15 ohms·cm |
| dielectric constant | | IEC60250 | 2.90 |
| dielectric constant | | | 2.80 |
| Dissipation Factor | | IEC60250 | 5.4E-03 |
| Dissipation Factor | | IEC60250 | 8.2E-03 |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| Hot deformation temperature 3 | | ISO75-2/B | 102 °C |
| Hot deformation temperature 3 | | ISO75-2/A | 97.0 °C |
| vicat | | ISO306/A50 | 104 °C |
| vicat | | ISO306/B50 | 96.0 °C |
| | ISO11359-2 | 8.0E-5到1.1E-4 cm/cm/°C |
| thermal conductivity | | DIN52612 | 0.17 W/m/K |
| maximum service temperature | | | 80 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare
View Prices