Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| Water absorption rate | | ISO 62 | 0.20 % |
| density | | ISO 1183 | 1.40 g/cm³ |
| Apparent density | | | 0.85 g/cm³ |
| Melt volume flow rate | | ISO 1133 | 11.0 cm³/10min |
| Shrinkage rate | | ISO 294-4 | 2.1 % |
| Shrinkage rate | | ISO 294-4 | 2.1 % |
| Water absorption rate | | ISO 62 | 0.80 % |
| hardness | Test Condition | Test Method | Test Result |
|---|
| ball-indentation hardness | | ISO 2039-1 | 145 MPa |
| flammability | Test Condition | Test Method | Test Result |
|---|
| Flammability level | | IEC 60695-11-10,-20 | HB |
| Supplementary Information | Test Condition | Test Method | Test Result |
|---|
| ISOType | | ISO 9988-1 | POM-K.M-GNR.04-002 |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| Tensile modulus | | ISO 527-2 | 2700 MPa |
| tensile strength | Yield | ISO 527-2/50 | 65.0 MPa |
| Tensile strain | Yield | ISO 527-2/50 | 9.0 % |
| Nominal tensile fracture strain | | ISO 527-2/50 | 28 % |
| Tensile creep modulus | | ISO 899-1 | 1300 MPa |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Charpy Notched Impact Strength | | ISO 179/1eA | 5.0 kJ/m² |
| Charpy Notched Impact Strength | | ISO 179/1eA | 5.5 kJ/m² |
| Impact strength of simply supported beam without notch | | ISO 179/1eU | 170 kJ/m² |
| Impact strength of simply supported beam without notch | | ISO 179/1eU | 180 kJ/m² |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| Compared to the Leakage Tracking Index (CTI) | | IEC 60112 | PLC 0 |
| Surface Resistivity | | IEC 60093 | 1E+13 ohms |
| Volume resistivity | | IEC 60093 | 1E+15 ohms·cm |
| relative permittivity | | IEC 60250 | 3.80 |
| Dissipation Factor | | IEC 60250 | 5E-03 |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| Heat distortion temperature | | ISO 75-2/A | 100 °C |
| melting temperature | | ISO 11357-3 | 167 °C |
| Linear coefficient of thermal expansion | | ISO 11359-2 | 1.1E-04 cm/cm/°C |
| maximum service temperature | | | 100 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare