
PC/ABS 4230 DAICEL JAPAN
9
Form:Granules
Properties:
Glass fiber reinforcedFlame retardantFiller: Glass fiber reinf30%Filler by weight
Product Description
Certificates(0)
Datasheet
Product Description
| Properties: | Glass fiber reinforced | Flame retardant | Filler: Glass fiber reinf | 30% | Filler by weight |
Certificates
No Data...
Technical Data Sheet
| flammability | Test Condition | Test Method | Test Result | Test Unit |
|---|---|---|---|---|
| UL flame retardant rating | 2.0mm | UL 94 | 5VA | |
| 1.5mm | UL 94 | V-0 | ||
| mechanical properties | Test Condition | Test Method | Test Result | Test Unit |
| bending strength | ISO 178 | 145 | Mpa | |
| Bending modulus | ISO 178 | 7700 | Mpa | |
| tensile strength | Yield | ISO 527-2 | 92.0 | Mpa |
| thermal performance | Test Condition | Test Method | Test Result | Test Unit |
| Hot deformation temperature | 1.8MPa,Unannealed,6.40mm | ASTM D648 | 123 | °C |
| Linear coefficient of thermal expansion | TD | ISO 11359-2 | 8E-05 | cm/cm/°C |
| MD | ISO 11359-2 | 3E-05 | cm/cm/°C | |
| Hot deformation temperature | 1.8MPa,Unannealed | ISO 75-2/A | 116 | °C |
| Physical properties | Test Condition | Test Method | Test Result | Test Unit |
| Water absorption rate | 23°C,24hr | ISO 62 | 0.30 | % |
| Shrinkage rate | MD | ASTM D955 | 0.10-0.40 | % |
| Electrical performance | Test Condition | Test Method | Test Result | Test Unit |
| Hot wire ignition | 1.5mm | UL 746 | PLC 0 | |
| High voltage arc tracing rate | 3.00mm | UL 746 | PLC 4 | |
| High arc combustion index | 1.5mm | UL 746 | PLC 0 | |
| Compared to the anti leakage trace index | 3.00mm | UL 746 | PLC 4 | |
| Arc resistance | 3.00mm | ASTM D495 | PLC6 | |
| 3.00mm | ASTM D495 | 69.0 | sec | |
| Dielectric strength | 1.50mm | ASTM D149 | 26 | KV/mm |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.