
Phenolic Sumikon® PM-9640 (Injection) SBHPP
Product Description
Certificates(0)
Datasheet
Product Description
Certificates
No Data...
Technical Data Sheet
| impact performance | Test Condition | Test Method | Test Result | Test Unit |
|---|---|---|---|---|
| Suspended wall beam without notch impact strength | ASTM D256 | 40 | J/m | |
| flammability | Test Condition | Test Method | Test Result | Test Unit |
| UL flame retardant rating | 1.5mm | UL 94 | V-0 | |
| 3.0mm | UL 94 | V-0 | ||
| 6.0mm | UL 94 | V-0 | ||
| mechanical properties | Test Condition | Test Method | Test Result | Test Unit |
| Tensile modulus | ASTM D638 | 18600 | MPa | |
| tensile strength | ASTM D638 | 138 | MPa | |
| bending strength | ASTM D790 | 227 | MPa | |
| compressive strength | ASTM D695 | 276 | MPa | |
| thermal performance | Test Condition | Test Method | Test Result | Test Unit |
| Linear coefficient of thermal expansion | MD:23to60°C | 2.4E-05 | cm/cm/°C | |
| RTI Elec | 3.0mm | UL 746 | 150 | °C |
| Hot deformation temperature | HDT | ASTM D648 | 204 | °C |
| Physical properties | Test Condition | Test Method | Test Result | Test Unit |
| density | ASTM D792 | 1.78 | g/cm³ | |
| Apparent density | ASTM D1895 | 0.80 | g/cm³ | |
| Shrinkage rate | MD | ASTM D6289 | 0.30 | % |
| Water absorption rate | Equilibrium | ASTM D570 | 0.050 | % |
| Electrical performance | Test Condition | Test Method | Test Result | Test Unit |
| Dielectric strength | --2 | ASTM D149 | 18 | kV/mm |
| --3 | ASTM D149 | 16 | kV/mm | |
| Dielectric constant | 1MHz | ASTM D150 | 4.30 | |
| Dissipation factor | 1MHz | ASTM D150 | 0.020 | |
| Volume resistivity | ASTM D257 | 1E+12 | ohms·cm | |
| hardness | Test Condition | Test Method | Test Result | Test Unit |
| Rockwell hardness | M-Scale | 120 |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.