Share
Add to compare

PA66 A RV 150K RADIC ITALY

37

Form:Granules | Grade:Injection grade

Product Description
Certificates(0)
Datasheet

Product Description

Certificates

No Data...

Technical Data Sheet

impact performanceTest ConditionTest MethodTest ResultTest Unit
Impact strength of simply supported beam without notch23°CISO 179/1eU39kJ/m²
Impact strength of simply supported beam without notch-30°CISO 179/1eU32kJ/m²
flammabilityTest ConditionTest MethodTest ResultTest Unit
flammabilityFMVSS 3020mm/min
Burning wire flammability index2.0 mmIEC 60695-2-12700°C
UL flame retardant rating0.8 mmUL 94HB
mechanical propertiesTest ConditionTest MethodTest ResultTest Unit
bending strengthISO 178190Mpa
Bending modulusISO 1785200Mpa
Tensile strainBreakISO 527-2/1A/52.9%
tensile strengthBreakISO 527-2/1A/5120Mpa
Tensile modulusISO 527-2/1A/15800Mpa
injectionTest ConditionTest MethodTest ResultTest Unit
Processing (melt) temperature280 to 300°C
Mold temperature80 to 100°C
Injection speed中等
Suggested maximum moisture content0.15%
Dew Point - Hot Air Drying Machine-20°C
Drying time - hot air dryer2.0 to 4.0hr
Drying temperature - hot air dryer80°C
thermal performanceTest ConditionTest MethodTest ResultTest Unit
Melting temperatureISO 11357-3260°C
Vicat softening temperatureISO 306/B50245°C
Hot deformation temperature1.8 MPa, UnannealedISO 75-2/Af220°C
Hot deformation temperature0.45 MPa, UnannealedISO 75-2/Bf245°C
Physical propertiesTest ConditionTest MethodTest ResultTest Unit
Shrinkage rate横向FlowISO 294-40.90%
Water absorption rateEquilibrium, 23°C, 2.00 mm, 50% RHISO 622.3%
Water absorption rateSaturation, 23°C, 2.00 mmISO 627.9%
Shrinkage rateFlowISO 294-40.40%
Electrical performanceTest ConditionTest MethodTest ResultTest Unit
Compared to the anti leakage trace indexSolution AIEC 60112PLC 0
Volume resistivityIEC 600931.0E+15ohms·cm
Surface resistivityIEC 600931.0E+12ohms
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.