mechanical properties	Test Condition	Test Method	Test Result	Test Unit
Tensile modulus		ISO 527-1/-2	10000	Mpa
tensile strength		ISO 527-1/-2	135	Mpa
elongation	Break	ISO 527-1/-2	2.5	%
Tensile creep modulus		ISO 899-1	7500	Mpa
Impact strength of simply supported beam without notch	23℃	ISO 179/1eU	67	KJ/m
Charpy Notched Impact Strength	23℃	ISO 179/1eA	11	KJ/m
bending strength		ISO 178	200	Mpa
thermal performance	Test Condition	Test Method	Test Result	Test Unit
Melt Volume Flow Rate (MVR)		ISO 1133	11	CM
Melting temperature		ISO 11357-1	223	°C
UL flame retardant rating		UL 94	HB
Hot deformation temperature	1.8Mpa	ISO 75-1/-2	215	°C
Hot deformation temperature	Hot deformation temperature	0.45Mpa	ISO 75-1/-2	220	°C
Linear coefficient of thermal expansion		ISO 11359-2	0.2-0.3	E-4/℃
Physical properties	Test Condition	Test Method	Test Result	Test Unit
Viscosity coefficient		ISO 307	102	CM
Water absorption rate	23℃,Saturation	ISO 62	0.4	%
Water absorption rate	Water absorption rate	23℃,50%相对湿度	ISO 62	0.2	%
Shrinkage rate	Across Flow		0.2	%
Shrinkage rate	Shrinkage rate	Across Flow		1.1	%
Electrical performance	Test Condition	Test Method	Test Result	Test Unit
Volume resistivity	100Hz	IEC 60250	4
Volume resistivity	Volume resistivity	1MHz	IEC 60250	3.8
Dielectric dissipation factor	100Hz	亿厘60250	25	E-4
Dielectric dissipation factor	Dielectric dissipation factor	1MHz	IEC 60250	170	E-4
Volume resistivity		IEC 60093	1E+16	ohm.m
Compared to the Leakage Traceability Index (CTI)	A	IEC 60112	375
Compared to the Leakage Traceability Index (CTI)	Compared to the Leakage Traceability Index (CTI)	B	IEC 60112	125

IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.

Get App

Top