Technical Data Sheet
| physical property | Test Condition | Test Method | Test Result |
|---|
| Shrinkage rate | | ASTM D955 | 0.40-0.60 % |
| Water absorption rate | | ASTM D570 | 0.30 % |
| density | | ISO 1183 | 1.04 g/cm³ |
| melt mass-flow rate | | ISO 1133 | 40 g/10min |
| density | | ASTM D792 | 1.05 g/cm³ |
| hardness | Test Condition | Test Method | Test Result |
|---|
| Rockwell hardness | | ASTM D785 | 114 |
| flammability | Test Condition | Test Method | Test Result |
|---|
| UL flame retardant rating | | UL 94 | HB |
| Mechanical properties | Test Condition | Test Method | Test Result |
|---|
| bending strength | | ASTM D790 | 73.0 Mpa |
| bending strength | | ISO 178 | 77.0 Mpa |
| Flexural modulus | | ASTM D790 | 2300 Mpa |
| Tensile modulus | | ISO 527-2/1 | 2600 Mpa |
| tensile strength | | ASTM D638 | 46.0 Mpa |
| tensile strength | | ISO 527-2/50 | 51.0 Mpa |
| elongation | | ASTM D638 | 15 % |
| Tensile strain | | ISO 527-2/50 | >10 % |
| Impact resistance | Test Condition | Test Method | Test Result |
|---|
| Impact strength of cantilever beam gap | | ASTM D256 | 160 J/m |
| Impact strength of cantilever beam gap | | ASTM D256 | 110 J/m |
| Impact strength of cantilever beam gap | | ASTM D256 | 80 J/m |
| Impact strength of cantilever beam gap | | ASTM D256 | 110 J/m |
| Charpy Notched Impact Strength | | ISO 179/1eA | 18 kJ/m² |
| Impact strength of cantilever beam gap | | ASTM D256 | 220 J/m |
| Impact strength of cantilever beam gap | | ASTM D256 | 200 J/m |
| Electrical performance | Test Condition | Test Method | Test Result |
|---|
| dielectric strength | | ASTM D149 | 23 KV/mm |
| dielectric constant | | ASTM D150 | 3.10 |
| Surface Resistivity | | ASTM D257 | >1.0E+16 ohms |
| Volume resistivity | | ASTM D257 | >1.0E+16 ohms·cm |
| Dissipation Factor | | ASTM D150 | 6.2E-03 |
| Thermal performance | Test Condition | Test Method | Test Result |
|---|
| Heat distortion temperature | | ISO 75-2/A | 81.0 °C |
| Linear coefficient of thermal expansion | | ASTM D696 | 7.2E-05 cm/cm/°C |
| thermal conductivity | | ASTMC177 | 0.16 W/m/K |
| Heat distortion temperature | | ASTM D648 | 92.0 °C |
| Heat distortion temperature | | ASTM D648 | 86.0 °C |
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
Compare