Material Comparison

Product Info

Product Name

Brand Name

Usages

Properties

Certificates

PSU P-1700 NT SOLVAY USA

UDEL®

Electrical field,Electronic field,Electrical components,Electrical appliances,valve,Valve components,Industrial components,Pipeline components,Pipeline components,Home appliance components,Automotive sector,Food service sector,Surgical instruments,Microwave cooker,Dental application field,Medical supplies,Nursing supplies,Medical devices,Medical devices

dimensional stability ,Electron beam disinfectio,Radiopable,Radiation disinfection,Pressure cooker disinfect,Good disinfection perform,Ethylene oxide disinfecti,Anti gamma radiation,Chemical resistance,Alkali resistant,Alcohol resistance,heat-resisting,Acid resistance,Resistance to hydrocarbon,Detergent resistant,Steam resistant,Thermal disinfection,High toughness,Biocompatibility,Food contact compliance,Hydrolysis resistance,Disinfect with steam,Excellent appearance

Plastic Datasheets

thermal performance	Test Condition	Test Method	SOLVAY USA/P-1700 NT
Hot deformation temperature	1.8MPa,未退火	ASTM D648	174 °C
Linear coefficient of thermal expansion	MD	ASTM D696	5.6E-05 cm/cm/°C

mechanical properties	Test Condition	Test Method	SOLVAY USA/P-1700 NT
Bending modulus		ASTM D790	2690 Mpa
bending strength		ASTM D790	106 Mpa
elongation	断裂	ASTM D638	50to100 %
Tensile modulus		ASTM D638	2480 Mpa
tensile strength		ASTM D638	70.3 Mpa

Electrical performance	Test Condition	Test Method	SOLVAY USA/P-1700 NT
Dielectric constant	1MHz	ASTM D150	3.02
		1kHz	ASTM D150	3.04
		60Hz	ASTM D150	3.03
Dielectric strength		ASTM D149	17 KV/mm
Dissipation factor	1MHz	ASTM D150	6E-03
		60Hz	ASTM D150	7E-04
		1kHz	ASTM D150	1E-03
Volume resistivity		ASTM D257	3E+16 ohms·cm

Physical properties	Test Condition	Test Method	SOLVAY USA/P-1700 NT
density		ASTM D792	1.24 g/cm³
melt mass-flow rate	343°C/2.16kg	ASTM D1238	6.5 g/10min
Shrinkage rate	MD	ASTM D955	0.70 %
Water absorption rate	24hr	ASTM D570	0.30 %

impact performance	Test Condition	Test Method	SOLVAY USA/P-1700 NT
Impact strength of cantilever beam gap		ASTM D256	69 J/m
Impact strength of cantilever beam gap			ASTM D1822	420 kJ/m²

flammability	Test Condition	Test Method	SOLVAY USA/P-1700 NT
Burning wire flammability index	0.8mm	IEC 60695-2-12	850 °C
Burning wire flammability index		1.6to6.0mm	IEC 60695-2-12	960 °C
Hot filament ignition temperature	1.6to6.0mm	IEC 60695-2-13	850 °C
Hot filament ignition temperature		0.8mm	IEC 60695-2-13	875 °C
UL flame retardant rating	4.5mm	UL 94	V-0
UL flame retardant rating		1.5mm	UL 94	HB

Get App

Top