Material Comparison
Product Info
Product Name
Brand Name
Usages
Properties
Certificates

PC/PET MB2105 MITSUBISHI ENGINEERING JAPAN
IUPILON™
Electronic and Electrical Applications
Antichemical
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Plastic Datasheets
thermal performance | Test Condition | Test Method | MITSUBISHI ENGINEERING JAPAN/MB2105 |
---|---|---|---|
Hot deformation temperature | 0.45MPa,Unannealed | ISO 75-2/B | 136 °C |
1.8MPa,Unannealed | ISO 75-2/A | 112 °C | |
Linear coefficient of thermal expansion | TD | ISO 11359-2 | 7E-05 cm/cm/°C |
MD | ISO 11359-2 | 6E-05 cm/cm/°C |
mechanical properties | Test Condition | Test Method | MITSUBISHI ENGINEERING JAPAN/MB2105 |
---|---|---|---|
Bending modulus | ISO 178 | 2300 Mpa | |
bending strength | ISO 178 | 90.0 Mpa | |
Nominal tensile fracture strain | ISO 527-2 | 90 % | |
Tensile modulus | ISO 527-2 | 2300 Mpa | |
Tensile strain | Yield | ISO 527-2 | 5.2 % |
tensile strength | Yield | ISO 527-2 | 57.0 Mpa |
Physical properties | Test Condition | Test Method | MITSUBISHI ENGINEERING JAPAN/MB2105 |
---|---|---|---|
melt mass-flow rate | 300°C/1.2kg | ISO 1133 | 7.1 g/10min |
Melt Volume Flow Rate (MVR) | 300°C/1.2kg | ISO 1133 | 6.90 cm3/10min |
Shrinkage rate | 吸水率(Saturation,23°C) | 0.20 % | |
MD:3.20mm | 0.60-0.80 % | ||
TD:3.20mm | 0.60-0.80 % |
impact performance | Test Condition | Test Method | MITSUBISHI ENGINEERING JAPAN/MB2105 |
---|---|---|---|
Impact strength of simply supported beam without notch | 23°C | ISO 179 | NoBreak |