Material Comparison
Product Info
Product Name
Brand Name
Usages
Properties
Certificates

PEI Tempalux® Unfilled Westlake Plastics Company
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Plastic Datasheets
Impact resistance | Test Condition | Test Method | Westlake Plastics Company/Tempalux® Unfilled |
---|---|---|---|
Suspended wall beam without notch impact strength | ASTM D256 | 1300 J/m | |
Impact strength of cantilever beam gap | 23°C | ASTM D256 | 53 J/m |
hardness | Test Condition | Test Method | Westlake Plastics Company/Tempalux® Unfilled |
---|---|---|---|
Rockwell hardness | M级 | ASTM D785 | 109 |
Mechanical properties | Test Condition | Test Method | Westlake Plastics Company/Tempalux® Unfilled |
---|---|---|---|
elongation | 断裂 | ASTM D638 | 60 % |
屈服 | ASTM D638 | 7.0 % | |
compressive strength | ASTM D695 | 151 MPa | |
bending strength | 屈服 | ASTM D790 | 152 MPa |
Tensile modulus | ASTM D638 | 2960 MPa | |
Flexural modulus | ASTM D790 | 3310 MPa | |
Compression Modulus | ASTM D695 | 3310 MPa | |
tensile strength | 屈服 | ASTM D638 | 105 MPa |
Electrical performance | Test Condition | Test Method | Westlake Plastics Company/Tempalux® Unfilled |
---|---|---|---|
Dissipation Factor | 1kHz | ASTM D150 | 1.3E-03 |
Volume resistivity | ASTM D257 | 1E+17 ohms·cm | |
dielectric strength | ASTM D149 | 33 kV/mm | |
dielectric constant | 1kHz | ASTM D150 | 3.15 |
flammability | Test Condition | Test Method | Westlake Plastics Company/Tempalux® Unfilled |
---|---|---|---|
UL flame retardant rating | 1.9mm | UL 94 | 5VA |
Limiting Oxygen Index | ASTM D2863 | 47 % |
physical property | Test Condition | Test Method | Westlake Plastics Company/Tempalux® Unfilled |
---|---|---|---|
Water absorption rate | 24hr | ASTM D570 | 0.25 % |
density | ASTM D792 | 1.27 g/cm³ |
Thermal performance | Test Condition | Test Method | Westlake Plastics Company/Tempalux® Unfilled |
---|---|---|---|
Heat distortion temperature | 1.8MPa,未退火,HDT | ASTM D648 | 200 °C |
0.45MPa,未退火,HDT | ASTM D648 | 210 °C | |
thermal conductivity | ASTMC177 | 0.22 W/m/K | |
Linear coefficient of thermal expansion | MD | ASTM D696 | 5.6E-05 cm/cm/°C |
Contact Us
Get App
Top