plas

Material Comparison

Product Info
Product Name
Brand Name
Usages
Properties
Certificates
PC HL-8000 MITSUBISHI ENGINEERING JAPAN
IUPILON™ 
Fitness equipment,parts
High mobility
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--

Plastic Datasheets

thermal performanceTest ConditionTest MethodMITSUBISHI ENGINEERING JAPAN/HL-8000
Hot deformation temperature0.45MPa,UnannealedISO 75-2/B132 °C
1.8MPa,UnannealedISO 75-2/A118 °C
Linear coefficient of thermal expansionTDISO 11359-26.6E-05 cm/cm/°C
MDISO 11359-26.5E-05 cm/cm/°C
mechanical propertiesTest ConditionTest MethodMITSUBISHI ENGINEERING JAPAN/HL-8000
Bending modulusISO 1782500 Mpa
bending strengthISO 178100 Mpa
Nominal tensile fracture strainISO 527-285 %
Tensile modulusISO 527-22400 Mpa
Tensile strainYieldISO 527-25.7 %
tensile strengthYieldISO 527-265.0 Mpa
Electrical performanceTest ConditionTest MethodMITSUBISHI ENGINEERING JAPAN/HL-8000
Dielectric strength1.00mmIEC 60243-131 KV/mm
3.00mmIEC 60243-118 KV/mm
Dissipation factor1MHzIEC 602509E-03
100HzIEC 602506E-04
Relative permittivity100HzIEC 602503.10
1MHzIEC 602503.10
Surface resistivityIEC 600936E+15 ohms
Volume resistivityIEC 600933E+16 ohms·cm
Physical propertiesTest ConditionTest MethodMITSUBISHI ENGINEERING JAPAN/HL-8000
melt mass-flow rate300°C/1.2kgISO 1133140 g/10min
Melt Volume Flow Rate (MVR)300°C/1.2kgISO 1133136 cm3/10min
Shrinkage rate吸水率(Saturation,23°C)0.24 %
MD:3.20mm0.40-0.60 %
TD:3.20mm0.40-0.60 %
impact performanceTest ConditionTest MethodMITSUBISHI ENGINEERING JAPAN/HL-8000
Impact strength of simply supported beam without notch23°CISO 179NoBreak
flammabilityTest ConditionTest MethodMITSUBISHI ENGINEERING JAPAN/HL-8000
UL flame retardant rating0.38mmUL 94V-2