Material Comparison
Product Info
Product Name
Brand Name
Usages
Properties
Certificates

POM FB-2025S MITSUBISHI ENGINEERING JAPAN
Iupital™
Automotive sector,Electronic and Electrical Applications
wear resistant,High mobility,Glass addition
UL
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Plastic Datasheets
thermal performance | Test Condition | Test Method | MITSUBISHI ENGINEERING JAPAN/FB-2025S |
---|---|---|---|
Hot deformation temperature | 455Kpa | ASTM D648 | 162 °C |
820Kpa | ASTM D648 | 135 °C | |
UL flame retardant rating | UL 94 | HB |
mechanical properties | Test Condition | Test Method | MITSUBISHI ENGINEERING JAPAN/FB-2025S |
---|---|---|---|
Bending modulus | 23℃ | ASTM D790 | 3.58 GPa |
bending strength | 23℃ | ASTM D790 | 99 Mpa |
Impact strength of cantilever beam gap | 3.2mm | ASTM D256 | 64 J/m |
Rockwell hardness | ASTM D785 | 83 M | |
Stretching length | 23℃ | ASTM D638 | 10 % |
tensile strength | 23℃ | ASTM D638 | 61.8 Mpa |
Electrical performance | Test Condition | Test Method | MITSUBISHI ENGINEERING JAPAN/FB-2025S |
---|---|---|---|
Dielectric constant | 10 | ASTM D150 | 33 Pf/m |
Dielectric loss | 10,Tangent | ASTM D150 | -- |
Dielectric strength | ASTM D149 | 20 MV/m | |
Surface resistivity | ASTM D257 | 1×10 | |
Volume resistivity | ASTM D257 | 1×10 |
Physical properties | Test Condition | Test Method | MITSUBISHI ENGINEERING JAPAN/FB-2025S |
---|---|---|---|
Filling content | 25 % | ||
melt mass-flow rate | ASTM D1238 | 5.0 g/10min | |
Shrinkage rate | Flow | 1.6 % | |
Water absorption rate | ASTM D570 | 0.20 % |