Material Comparison

Product Info
Product Name
Brand Name
Usages
Properties
Certificates
DAP Synres-Almoco DAIP 6552 Synres-Almoco BV
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--

Plastic Datasheets

Impact resistanceTest ConditionTest MethodSynres-Almoco BV/Synres-Almoco DAIP 6552
Impact strength of simply supported beam without notch注塑ISO 179/1eU5.0to7.0 kJ/m²
Charpy Notched Impact Strength注塑ISO 179/1eA2.5to4.0 kJ/m²
Mechanical propertiesTest ConditionTest MethodSynres-Almoco BV/Synres-Almoco DAIP 6552
bending strength注塑ISO 178120to150 MPa
Flexural modulus注塑ISO 17810000to15000 MPa
compression stressISO 604150to200 MPa
tensile strength 注塑ISO 527-260.0to80.0 MPa
Tensile modulus注塑ISO 527-26000to8000 MPa
Electrical performanceTest ConditionTest MethodSynres-Almoco BV/Synres-Almoco DAIP 6552
Compared to the Leakage Tracking Index (CTI)IEC 60112PLC 1
dielectric strengthIEC 60243-115to20 kV/mm
Volume resistivityIEC 600931.0E+14到1.0E+15 ohms·cm
Dissipation Factor100HzIEC 602500.010to0.030
relative permittivity100HzIEC 602504.005.00
arc resistanceASTM D495PLC 4
relative permittivity1MHzIEC 602504.005.00
Surface ResistivityIEC 600931.0E+14到1.0E+15 ohms
Dissipation Factor1MHzIEC 602500.010to0.030
flammabilityTest ConditionTest MethodSynres-Almoco BV/Synres-Almoco DAIP 6552
Hot filament ignition temperatureIEC 60695-2-13960 °C
Burning wire flammability indexIEC 60695-2-12960 °C
physical property Test ConditionTest MethodSynres-Almoco BV/Synres-Almoco DAIP 6552
Shrinkage rateISO 2577<0.050 %
Apparent densityISO 600.70to0.85 g/cm³
Water absorption rate23°C,24hrISO 62<0.20 %
Shrinkage rateMD2ISO 25770.20to0.45 %
densityISO 11831.80to2.00 g/cm³
Thermal performanceTest ConditionTest MethodSynres-Almoco BV/Synres-Almoco DAIP 6552
Linear coefficient of thermal expansionMD:50到100°CISO 11359-25.0E-5到6.0E-5 cm/cm/°C
Heat distortion temperature8.0MPa,未退火,HDTISO 75-2/C>200 °C
thermal conductivityASTME14610.40to0.60 W/m/K

Contact Us

Get App

Top