Material Comparison
Product Info
Product Name
Brand Name
Usages
Properties
Certificates

PEEK 770CA30 JILIN JOINATURE
ZYPEEK®
Aerospace,Wire and cable,Automotive sector,Nursing supplies,Medical supplies,Electronic field,Electrical field
Carbon fiber reinforced,enhance
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Plastic Datasheets
thermal performance | Test Condition | Test Method | JILIN JOINATURE/770CA30 |
---|---|---|---|
Hot deformation temperature | 1.8 Mpa | ISO 75-f | 336 °C |
Linear coefficient of thermal expansion | 低于Tg沿着Flow | ISO 11359 | 5 ppm/K |
高于Tg沿着Flow | ISO 11359 | 6 ppm/K | |
Melting temperature | ISO 11357 | 343 °C | |
specific heat | 23℃ | DSC | 1.8 kJ/kg /℃ |
Tg (initial) | ISO 11357 | 143 °C | |
thermal conductivity | 23℃ | ISO 22007-4 | 0.95 W/m/K |
mechanical properties | Test Condition | Test Method | JILIN JOINATURE/770CA30 |
---|---|---|---|
Bending modulus | 23℃ | ISO 178 | 23000 Mpa |
bending strength | Break,23℃ | ISO 178 | 380 Mpa |
compressive strength | 23℃ | ISO 604 | 300 Mpa |
Shore hardness | 23℃ | ISO 868 | 88 D 级 |
Tensile strain | Break,23℃ | ISO 527 | 1.7 % |
tensile strength | Break,23℃ | ISO 527 | 260 Mpa |
Electrical performance | Test Condition | Test Method | JILIN JOINATURE/770CA30 |
---|---|---|---|
Volume resistivity | 23 ℃,1V | IEC 60093 | 10^5 ohms·cm |
Physical properties | Test Condition | Test Method | JILIN JOINATURE/770CA30 |
---|---|---|---|
density | 结晶 | ISO 1183 | 1.4 g/cm³ |
melt mass-flow rate | 380℃,5.0kg | ISO 1133 | 2.3 g/10min |
Shrinkage rate | MD | ISO 294-4 | 0.5 % |
TD | ISO 294-4 | 0.1 % | |
Water absorption rate | 23℃,24hr,3.2 mm厚拉伸棒 | ISO 62-1 | 0.04 % |
Equilibrium,23℃ | ISO 62-1 | 0.3 % |
impact performance | Test Condition | Test Method | JILIN JOINATURE/770CA30 |
---|---|---|---|
Charpy Notched Impact Strength | ISO 179-1eA | 7 kJ/m² | |
Impact strength of cantilever beam gap | ISO 180/A | 9 kJ/m² | |
Impact strength of simply supported beam without notch | ISO 179/1U | 45 kJ/m² | |
Suspended wall beam without notch impact strength | ISO 180/U | 45 kJ/m² |