plas

Material Comparison

Product Info
Product Name
Brand Name
Usages
Properties
Certificates
POM SW-22 JAPAN POLYPLASTIC
DURACON®
Automotive sector
High hardness,High rigidity,High sliding,High mobility,currency
UL
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--

Plastic Datasheets

hardnessTest ConditionTest MethodJAPAN POLYPLASTIC/SW-22
Rockwell hardnessM-ScaleISO 2039-275
Supplementary InformationTest ConditionTest MethodJAPAN POLYPLASTIC/SW-22
ColourNumberCF2001
thermal performanceTest ConditionTest MethodJAPAN POLYPLASTIC/SW-22
Hot deformation temperature1.8MPa,UnannealedISO 75-2/A95.0 °C
Linear coefficient of thermal expansionMD:23to55°CInternal Method9E-05 cm/cm/°C
TD:23to55°CInternal Method1.1E-04 cm/cm/°C
mechanical propertiesTest ConditionTest MethodJAPAN POLYPLASTIC/SW-22
Bending modulusISO 1783200 Mpa
bending strengthISO 17883.0 Mpa
Friction coefficientDynamic2JISK72180.19
Steel - Dynamic3JISK72180.20
Tensile modulusISO 527-23500 Mpa
Tensile strainBreakISO 527-26.0 %
tensile strengthISO 527-250.0 Mpa
Wear factor0.98MPa,0.30m/sec4JISK7218<1.0 10^-8mm³/N·m
0.98MPa,0.30m/sec5JISK721822 10^-8mm³/N·m
0.060MPa,0.15m/sec6JISK7218300 10^-8mm³/N·m
0.060MPa,0.15m/sec7JISK7218450 10^-8mm³/N·m
Physical propertiesTest ConditionTest MethodJAPAN POLYPLASTIC/SW-22
densityISO 11831.47 g/cm³
melt mass-flow rate190°C/2.16kgISO 113315 g/10min
Melt Volume Flow Rate (MVR)190°C/2.16kgISO 113312.0 cm3/10min
Shrinkage rateTD:2.00mmISO 294-41.4 %
MD:2.00mmISO 294-41.7 %
Water absorption rate23°C,24hrISO 620.50 %
impact performanceTest ConditionTest MethodJAPAN POLYPLASTIC/SW-22
Charpy Notched Impact Strength23°CISO 179/1eA2.8 kJ/m²
flammabilityTest ConditionTest MethodJAPAN POLYPLASTIC/SW-22
UL flame retardant ratingUL 94HB