Material Comparison
Product Info
Product Name
Brand Name
Usages
Properties
Certificates
PA6 Plaslube® PA6 GF10 TL10 Techmer Polymer Modifiers
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Plastic Datasheets
| Impact resistance | Test Condition | Test Method | Techmer Polymer Modifiers/Plaslube® PA6 GF10 TL10 |
|---|---|---|---|
| Impact strength of cantilever beam gap | 23°C,3.18mm | ASTM D256 | 64 J/m |
| hardness | Test Condition | Test Method | Techmer Polymer Modifiers/Plaslube® PA6 GF10 TL10 |
|---|---|---|---|
| Rockwell hardness | R级 | ASTM D785 | 117 |
| Mechanical properties | Test Condition | Test Method | Techmer Polymer Modifiers/Plaslube® PA6 GF10 TL10 |
|---|---|---|---|
| elongation | 断裂 | ASTM D638 | 3.5 % |
| tensile strength | 断裂 | ASTM D638 | 75.8 MPa |
| Flexural modulus | ASTM D790 | 3590 MPa | |
| bending strength | ASTM D790 | 103 MPa |
| Electrical performance | Test Condition | Test Method | Techmer Polymer Modifiers/Plaslube® PA6 GF10 TL10 |
|---|---|---|---|
| Volume resistivity | ASTM D257 | 3E+14 ohms·cm | |
| dielectric strength | ASTM D149 | 17 kV/mm |
| flammability | Test Condition | Test Method | Techmer Polymer Modifiers/Plaslube® PA6 GF10 TL10 |
|---|---|---|---|
| UL flame retardant rating | UL 94 | HB |
| physical property | Test Condition | Test Method | Techmer Polymer Modifiers/Plaslube® PA6 GF10 TL10 |
|---|---|---|---|
| Water absorption rate | 24hr | ASTM D570 | 1.1 % |
| density | ASTM D792 | 1.33 g/cm³ | |
| Shrinkage rate | MD：3.18mm | ASTM D955 | 0.60 % |
| Thermal performance | Test Condition | Test Method | Techmer Polymer Modifiers/Plaslube® PA6 GF10 TL10 |
|---|---|---|---|
| Heat distortion temperature | 1.8MPa,未退火，HDT | ASTM D648 | 204 °C |
| Linear coefficient of thermal expansion | MD | ASTM D696 | 5.4E-05 cm/cm/°C |
Contact Us
Get App
Top