plas
Log In

Material Comparison

Product Info
Product Name
Brand Name
Usages
Properties
Certificates
PC EFR2151HU K89030C MITSUBISHI GAS SHANGHAI
IUPILON™ 
Automotive components,Special for cast film
High temperature resistan,wear resistant
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--

Plastic Datasheets

thermal performanceTest ConditionTest MethodMITSUBISHI GAS SHANGHAI/EFR2151HU K89030C
Hot deformation temperature0.45MPa,UnannealedISO 75-2/B140 °C
1.8MPa,UnannealedISO 75-2/A126 °C
Linear coefficient of thermal expansionTDISO 11359-26.6E-05 cm/cm/°C
MDISO 11359-26.5E-05 cm/cm/°C
mechanical propertiesTest ConditionTest MethodMITSUBISHI GAS SHANGHAI/EFR2151HU K89030C
Bending modulusISO 1782500 Mpa
bending strengthISO 17893.0 Mpa
Nominal tensile fracture strainISO 527-2120 %
Tensile modulusISO 527-22300 Mpa
Tensile strainYieldISO 527-26.5 %
tensile strengthYieldISO 527-262.0 Mpa
Electrical performanceTest ConditionTest MethodMITSUBISHI GAS SHANGHAI/EFR2151HU K89030C
Dielectric strength1.00mmIEC 60243-131 KV/mm
3.00mmIEC 60243-118 KV/mm
Dissipation factor1MHzIEC 602509E-03
100HzIEC 602506E-04
Relative permittivity100HzIEC 602503.10
1MHzIEC 602503.10
Surface resistivityIEC 600936E+15 ohms
Volume resistivityIEC 600933E+16 ohms·cm
Physical propertiesTest ConditionTest MethodMITSUBISHI GAS SHANGHAI/EFR2151HU K89030C
melt mass-flow rate300°C/1.2kgISO 113315 g/10min
Melt Volume Flow Rate (MVR)300°C/1.2kgISO 113314.0 cm3/10min
Shrinkage rate吸水率(Saturation,23°C)0.24 %
MD:3.20mm0.50-0.70 %
TD:3.20mm0.50-0.70 %
impact performanceTest ConditionTest MethodMITSUBISHI GAS SHANGHAI/EFR2151HU K89030C
Impact strength of simply supported beam without notch23°CISO 179NoBreak
flammabilityTest ConditionTest MethodMITSUBISHI GAS SHANGHAI/EFR2151HU K89030C
UL flame retardant rating1.5mmUL 94V-0