Material Comparison
Product Info
Product Name
Brand Name
Usages
Properties
Certificates

PEI 3452-701 SABIC INNOVATIVE US
ULTEM™
Electrical components,Sports equipment
Dimensional stability,Middle flow
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Plastic Datasheets
thermal performance | Test Condition | Test Method | SABIC INNOVATIVE US/3452-701 |
---|---|---|---|
Hot deformation temperature | 1.8 MPa, Unannealed, 6.40 mm | ASTM D648 | 212 °C |
RTI | UL 746 | 180 °C | |
RTI Elec | UL 746 | 180 °C | |
RTI Imp | UL 746 | 180 °C |
mechanical properties | Test Condition | Test Method | SABIC INNOVATIVE US/3452-701 |
---|---|---|---|
Bending modulus | 100 mm Span | ASTM D790 | 12400 Mpa |
bending strength | Break, 100 mm Span | ASTM D790 | 179 Mpa |
elongation | Break | ASTM D638 | 1.4 % |
tensile strength | Break | ASTM D638 | 131 Mpa |
Electrical performance | Test Condition | Test Method | SABIC INNOVATIVE US/3452-701 |
---|---|---|---|
Arc resistance | ASTM D495 | PLC 5 | |
Compared to the anti leakage trace index | UL 746 | PLC 4 | |
High arc combustion index | UL 746 | PLC 4 | |
High voltage arc tracing rate | UL 746 | PLC 4 | |
Hot wire ignition | UL 746 | PLC 1 |
Physical properties | Test Condition | Test Method | SABIC INNOVATIVE US/3452-701 |
---|---|---|---|
melt mass-flow rate | 337°C/6.6 kg | ASTM D1238 | 4.6 g/10 min |
Shrinkage rate | Across FlowFlow : 3.20 mm | Internal Method | 0.30 - 0.50 % |
Flow : 3.20 mm | Internal Method | 0.15 - 0.25 % |
impact performance | Test Condition | Test Method | SABIC INNOVATIVE US/3452-701 |
---|---|---|---|
Reverse notch impact | 3.20 mm | ASTM D256 | 220 J/m |
flammability | Test Condition | Test Method | SABIC INNOVATIVE US/3452-701 |
---|---|---|---|
UL flame retardant rating | 3.0 mm | UL 94 | 5VA |
0.77 mm | UL 94 | V-0 |
injection | Test Condition | Test Method | SABIC INNOVATIVE US/3452-701 |
---|---|---|---|
Back pressure | 0.300 to 0.700 Mpa | ||
drying temperature | 150 °C | ||
drying time | 4.0 to 6.0 hr | ||
Exhaust hole depth | 0.025 to 0.076 mm | ||
Mold temperature | 135 to 165 °C | ||
Processing (melt) temperature | 350 to 400 °C | ||
Screw speed | 40 to 70 rpm | ||
Spray nozzle temperature | 345 to 400 °C | ||
Suggested injection volume | 40 to 60 % | ||
Suggested maximum moisture content | 0.020 % | ||
Temperature at the front of the material cylinder | 345 to 400 °C | ||
Temperature at the rear of the barrel | 330 to 400 °C | ||
Temperature in the middle of the barrel | 340 to 400 °C |