Material Comparison
Product Info
Product Name
Brand Name
Usages
Properties
Certificates
PA6 HiFill® PA6 CM40 HS Techmer Polymer Modifiers
--
--
Filler, Techmer, American Techmer
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Plastic Datasheets
| Impact resistance | Test Condition | Test Method | Techmer Polymer Modifiers/HiFill® PA6 CM40 HS |
|---|---|---|---|
| Suspended wall beam without notch impact strength | 3.18mm | ASTM D256 | 320 J/m |
| Impact strength of cantilever beam gap | 23°C,3.18mm | ASTM D256 | 53 J/m |
| hardness | Test Condition | Test Method | Techmer Polymer Modifiers/HiFill® PA6 CM40 HS |
|---|---|---|---|
| Rockwell hardness | R级 | ASTM D785 | 121 |
| Mechanical properties | Test Condition | Test Method | Techmer Polymer Modifiers/HiFill® PA6 CM40 HS |
|---|---|---|---|
| elongation | 断裂 | ASTM D638 | 3.0 % |
| tensile strength | 断裂 | ASTM D638 | 86.9 MPa |
| Flexural modulus | ASTM D790 | 5720 MPa | |
| bending strength | ASTM D790 | 131 MPa |
| Electrical performance | Test Condition | Test Method | Techmer Polymer Modifiers/HiFill® PA6 CM40 HS |
|---|---|---|---|
| Volume resistivity | ASTM D257 | 1E+13 ohms·cm | |
| dielectric strength | ASTM D149 | 18 kV/mm |
| physical property | Test Condition | Test Method | Techmer Polymer Modifiers/HiFill® PA6 CM40 HS |
|---|---|---|---|
| Water absorption rate | 24hr | ASTM D570 | 0.95 % |
| density | ASTM D792 | 1.48 g/cm³ | |
| Shrinkage rate | MD：3.18mm | ASTM D955 | 0.70 % |
| Thermal performance | Test Condition | Test Method | Techmer Polymer Modifiers/HiFill® PA6 CM40 HS |
|---|---|---|---|
| Heat distortion temperature | 1.8MPa,未退火，HDT | ASTM D648 | 119 °C |
| 0.45MPa,未退火，HDT | ASTM D648 | 204 °C | |
| Linear coefficient of thermal expansion | MD | ASTM D696 | 7.2E-06 cm/cm/°C |
Contact Us
Get App
Top