Technical Data Sheet hardness Test Condition Test Method Test Result Rockwell hardness R-Scale ASTM D785 103
thermal performance Test Condition Test Method Test Result Hot deformation temperature 1.8 MPa, Unannealed ASTM D648 279 °C Linear coefficient of thermal expansion Flow : 150°C Internal Method 1.3E-5 cm/cm/°C Linear coefficient of thermal expansion Across Flow : 150°C Internal Method 5.6E-5 cm/cm/°C thermal conductivity JIS R2618 0.52 W/m/K
flammability Test Condition Test Method Test Result UL flame retardant rating 0.30 mm UL 94 V-0 Extreme Oxygen Index ISO 527-1 48 % Solder resistance Internal Method 300 °C
Physical properties Test Condition Test Method Test Result Shrinkage rate 横向Flow Internal Method 1.2 % Shrinkage rate Flow Internal Method 0.18 % Water absorption rate Saturation ASTM D570 0.020 %
Electrical performance Test Condition Test Method Test Result Volume resistivity ASTM D257 1.0E+15 ohms·cm Dielectric constant 1 kHz ASTM D150 4.40 Dielectric constant 1 MHz ASTM D150 3.90 Dissipation factor 1 kHz ASTM D150 0.022 Dissipation factor 1 MHz ASTM D150 0.022 Arc resistance ASTM D495 130 sec Compared to the anti leakage trace index IEC 60112 PLC 4
injection Test Condition Test Method Test Result drying temperature 130 °C drying time 4.0 to 24 hr Temperature at the rear of the barrel 280 to 320 °C Temperature in the middle of the barrel 320 to 350 °C Temperature at the front of the material cylinder 340 to 370 °C Spray nozzle temperature 340 to 370 °C Processing (melt) temperature 360 °C Mold temperature 40 to 160 °C Injection pressure 80.0 to 160 Mpa Injection speed 中等偏快 Maintain pressure 20.0 to 40.0 Mpa Back pressure 1.00 to 5.00 Mpa Screw speed 50 to 100 rpm
mechanical properties Test Condition Test Method Test Result tensile strength ASTM D638 147 Mpa elongation Break ASTM D638 5.2 % Bending modulus 23°C ASTM D790 12300 Mpa Bending modulus 200°C ASTM D790 4900 Mpa bending strength 23°C ASTM D790 143 Mpa bending strength 200°C ASTM D790 33.0 Mpa shear strength ASTM D732 51.0 Mpa Poisson's ratio ASTM D785 0.46
impact performance Test Condition Test Method Test Result Suspended wall beam without notch impact strength 6.40 mm ASTM D256 410 J/m
IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.
