Filling analysis	Test Condition	Test Method	Test Result	Test Unit
Melt viscosity	240°C	ISO 11443-A	155	Pa·s
ISO			PC+ABS-FR(40)
impact performance	Test Condition	Test Method	Test Result	Test Unit
Suspended wall beam without notch impact strength	23°C	ISO 180	无断裂
flammability	Test Condition	Test Method	Test Result	Test Unit
UL flame retardant rating	1.5 mm	UL 94	V-0 5VB
Extreme Oxygen Index		ISO 4589-2	31	%
mechanical properties	Test Condition	Test Method	Test Result	Test Unit
Tensile modulus	23°C	ISO 527-2/1	2650	Mpa
tensile strength	Yield, 23°C	ISO 527-2/50	61.0	Mpa
tensile strength	tensile strength	Break, 23°C	ISO 527-2/50	44.0	Mpa
Tensile strain	Yield, 23°C	ISO 527-2/50	4.0	%
Tensile strain	Tensile strain	Break, 23°C	ISO 527-2/50	30	%
injection	Test Condition	Test Method	Test Result	Test Unit
Drying Temperature - Dry Air Dryer			80	°C
Drying time - Dry Air Dryer			4.0	hr
Suggested maximum moisture content			< 0.020	%
Suggested injection volume			30 to 70	%
Temperature at the rear of the barrel			220 to 230	°C
Temperature in the middle of the barrel			225 to 235	°C
Temperature at the front of the material cylinder			230 to 240	°C
Spray nozzle temperature			255 to 265	°C
Processing (melt) temperature			240 to 270	°C
Mold temperature			60 to 90	°C
Back pressure			5.00 to 15.0	Mpa
Exhaust hole depth			0.025 to 0.075	mm
thermal performance	Test Condition	Test Method	Test Result	Test Unit
Hot deformation temperature	0.45 MPa, Unannealed	ISO 75-2/B	86.0	°C
Hot deformation temperature	Hot deformation temperature	1.8 MPa, Unannealed	ISO 75-2/A	78.0	°C
Vicat softening temperature	--	ISO 306/B50	89.0	°C
Vicat softening temperature	Vicat softening temperature	--	ISO 306/B120	95.0	°C
Linear coefficient of thermal expansion	Flow : 23 to 55°C	ISO 11359-2	7.5E-5	cm/cm/°C
Linear coefficient of thermal expansion	Linear coefficient of thermal expansion	Across Flow : 23 to 55°C	ISO 11359-2	7.6E-5	cm/cm/°C
Physical properties	Test Condition	Test Method	Test Result	Test Unit
Melt Volume Flow Rate (MVR)	240°C/5.0 kg	ISO 1133	26.0	cm3/10min
Shrinkage rate	2.00 mm3	ISO 294-4	0.40 - 0.60	%
Shrinkage rate	Shrinkage rate	3.00 mm4	ISO 2577	0.40 - 0.60	%
Electrical performance	Test Condition	Test Method	Test Result	Test Unit
Surface resistivity		IEC 60093	5.0E+17	ohms
Volume resistivity	23°C	IEC 60093	2.0E+18	ohms·cm

IMPORTANT NOTES: Plas.com collected the data in the data sheet from the material manufacturers. Plas.com makes the best effort to improve the accuracy of the data, but has no responsibility for the data. We strongly recommend verifying the validity of the data with the material manufacturers before making a final decision.

Get App

Top