مقایسه مواد
اطلاعات محصول
نام محصول
نام برند
کاربردها
ویژگیها
گواهینامهها

UHMWPE L4640T-3 MITSUI CHEM JAPAN
LUBMER™
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
برگههای اطلاعات پلاستیک
hardness | شرایط آزمون | روش آزمون | MITSUI CHEM JAPAN/L4640T-3 |
---|---|---|---|
Rockwell hardness | R-Scale | ASTM D785 | 63 |
Supplementary Information | شرایط آزمون | روش آزمون | MITSUI CHEM JAPAN/L4640T-3 |
---|---|---|---|
HeatGenerationTemperature | Internal Method | 75 °C |
thermal performance | شرایط آزمون | روش آزمون | MITSUI CHEM JAPAN/L4640T-3 |
---|---|---|---|
Hot deformation temperature | 0.45MPa,Unannealed | ASTM D648 | 91.0 °C |
Linear coefficient of thermal expansion | MD | ASTM D696 | 1.2E-04 cm/cm/°C |
Vicat softening temperature | ASTM D15256 | 130 °C |
mechanical properties | شرایط آزمون | روش آزمون | MITSUI CHEM JAPAN/L4640T-3 |
---|---|---|---|
Bending modulus | 23°C,3.00mm,48.0mmSpan | ASTM D790 | 2300 Mpa |
bending strength | 23°C,3.00mm,48.0mmSpan | ASTM D790 | 45.0 Mpa |
elongation | Break,23°C | ASTM D638 | 9.0 % |
Friction coefficient | Dynamic | Internal Method | 0.17 |
tensile strength | Break,23°C | ASTM D638 | 47.0 Mpa |
Wear amount | Internal Method | 220 10^-8mm³/N·m |
Electrical performance | شرایط آزمون | روش آزمون | MITSUI CHEM JAPAN/L4640T-3 |
---|---|---|---|
Dielectric constant | 23°C | ASTM D150 | 2.50 |
Dielectric strength | ASTM D149 | 60 KV/mm | |
Dissipation factor | 1MHz | ASTM D150 | 1.0E-4到2.0E-4 |
Volume resistivity | ASTM D257 | 1.0E+17-1.0E+18 ohms·cm |
Physical properties | شرایط آزمون | روش آزمون | MITSUI CHEM JAPAN/L4640T-3 |
---|---|---|---|
limiting pv value | Internal Method | >0.50 MPa·m/s | |
melt mass-flow rate | 190°C/10.0kg | JISK7210 | 7.0 g/10min |
Shrinkage rate | MD:2.00mm | Internal Method | 1.5 % |
TD:2.00mm | Internal Method | 1.3 % | |
Spiral flow length | Internal Method | 33.0 CM | |
Water absorption rate | 24hr | ASTM D570 | <0.010 % |