مقایسه مواد
اطلاعات محصول
نام محصول
نام برند
کاربردها
ویژگیها
گواهینامهها

PC/CF CF15 LNP JAPAN
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
برگههای اطلاعات پلاستیک
| thermal performance | شرایط آزمون | روش آزمون | LNP JAPAN/CF15 |
|---|---|---|---|
| Hot deformation temperature | 1.8 MPa, Unannealed | ASTM D648 | 142 °C |
| 0.45 MPa, Unannealed | ASTM D648 | 146 °C | |
| Linear coefficient of thermal expansion | Flow | ASTM D696 | 3.2E-5 cm/cm/°C |
| mechanical properties | شرایط آزمون | روش آزمون | LNP JAPAN/CF15 |
|---|---|---|---|
| Bending modulus | 23°C | ASTM D790 | 11000 Mpa |
| bending strength | 23°C | ASTM D790 | 172 Mpa |
| elongation | Break, 23°C | ASTM D638 | 2.0 % |
| Tensile modulus | 23°C | ASTM D638 | 9720 Mpa |
| tensile strength | 23°C | ASTM D638 | 121 Mpa |
| Electrical performance | شرایط آزمون | روش آزمون | LNP JAPAN/CF15 |
|---|---|---|---|
| Surface resistivity | ASTM D257 | 1.0E+2 - 5.5E+5 ohms | |
| Volume resistivity | ASTM D257 | 1.0E+2 - 1.0E+5 ohms·cm |
| Physical properties | شرایط آزمون | روش آزمون | LNP JAPAN/CF15 |
|---|---|---|---|
| Shrinkage rate | 3.18 mm,Flow | ASTM D955 | 0.15 % |
| Water absorption rate | 24 hr | ASTM D570 | 0.15 % |
| injection | شرایط آزمون | روش آزمون | LNP JAPAN/CF15 |
|---|---|---|---|
| Back pressure | 0.00 to 0.689 Mpa | ||
| drying temperature | 121 °C | ||
| drying time | 2.0 to 4.0 hr | ||
| Injection speed | 中等 | ||
| Mold temperature | 71 to 88 °C | ||
| Processing (melt) temperature | 304 to 327 °C | ||
| Spray nozzle temperature | 310 to 327 °C | ||
| Suggested maximum moisture content | 0.10 % | ||
| Temperature at the front of the material cylinder | 310 to 327 °C | ||
| Temperature at the rear of the barrel | 302 to 316 °C | ||
| Temperature in the middle of the barrel | 316 to 332 °C |